I replaced 201 with this 210 on my long axis on my cnc , this axis had two motors to move carridge so I was worried I would have to replace both 201 boards to this 210 since the 201 is no longer available. I did not and my old frankenstein ez router cnc i have had for 15 years is purring like a champ again! you just cant keep these ez routers down! they just keep going and going and going and these top of the line gecko components are one of the reasons!!only complaint i had was those little screw terminals are a pain to get the larger wires into when in the tight space these boards are installed at in my cnc. If the holes for the screw terminals was just a big bigger it would make the change a lot easier. luckily this last one lasted 15 years and only went bad because of damage incurred from substrate falling and cutting wires to motor during operating.
